I needed a few bits and pieces to finish off my Celts.

First up were the casualty figures: unfortunately important the way I play! These are 3D prints from 3D Breed’s March or Die range printed by Bunker Miniatures.

These are great figures. I especially like the chaps with the spear sticking up out of them, and the mailed warrior with a sword but without his head! I even managed to use up the last few cloaks I had lying around and, yes, the figure underneath is fully painted.

Next up are some light infantry with slings: a troop type I will need when I field the Celts as Ancient British. I very much like the way the 3D Breed designs have translated into 28mm: very chunky figures, almost cubist in nature. They paint up very easily and are nicely posed. One slight issue: I always thought of the Celtic slingers as Iouantoues (youths) and these are definitely not that…I mean, check out the balding figure in the red and white stripes!

These size reasonably well with the Victrix figures that make up most of my army: only very slightly shorter even if they are quite a bit chunkier.

Finally we have one of the 3D Breed’s specials: one of the two druids that they offer. The other is more of a generic holy man with knife figure, so I’ve saved him for another use. The chap below is another antler-wearing ‘Herne the Hatstand’ so fits well with the general theme of my Celts. Lovely figure: paints up easily.

All the above are painted with Contrast paints on a Grey Seer undercoat, with any highlights etc done using standard acrylics. The cloaks are highly recommended and are from Weave of War.

Finally in today’s bulletin, we have the first bits of a 15mm Han Chinese army: three units of Billmen armed with the dagger-axe, and four units of Spearmen armed with, er, spears. These are Lurkio figures from the range now being made available again from Gripping Beast, with the command and standard anachronistically coming from Ten Kingdom’s Song Chinese range via Micks Bits on Etsy.

It was a bit odd painting relatively old school 15mm metal figures again after spending so much time on plastic and 3D printed 28mm figures, but I think they have turned out okay.

I will say that this project very much demonstrated the difference between metal casts and 3D prints: the 3D prints have much more animation in them, looking better overall even if the extra detail sometimes makes them more difficult to paint. I would have gone 3D printed Song all the way, but wanted an earlier Chinese army that can pass for Spring, Warring States, Han, Three Kingdoms etc. Once the Han are finished, I’ll probably eventually end up doing enough Song units to convert the army into a later Chinese army anyway!

Note that these are based ten to a 75mm frontage base (FK&P2 from Big Red Bat), which means I can now field three units of Billmen/Spearmen on a 15cms grid (two bases together) or six units of Billmen/Spearmen on a 10cm grid (one base). The standards are coloured in pairs (green, yellow, blue, red) to make pairing them easy.

Next up are three units of Crossbowmen, so another 60 figures in total. I think I might need some more red paint!